Skip to main content
Version: 0.6.0

Continue: auto-configure

This page documents the routerly clients configure continue auto-apply flow. For a general, manually-written walkthrough of pointing Continue at Routerly (including an Anthropic-mode example), see Integrations: Continue.dev.

Continue is an open-source AI coding assistant for VS Code and JetBrains. It speaks the OpenAI wire format and reads its provider settings from a YAML config file.

Support state: auto-configurable. routerly clients configure writes this file for you. Config file: ~/.continue/config.yaml (YAML) Wire format: OpenAI


With the CLI installed and logged in:

routerly clients configure continue --router <your-router>

This mints a router token (or reuses one you pass with --token), backs up your existing ~/.continue/config.yaml, and appends a model entry to the models: array. Any other entry already in the file is left untouched.

Minting a new token requires router:write permission on the target router (use --token <existing-token> to skip this).

Manual configuration​

Open ~/.continue/config.yaml and add an entry to models::

name: Routerly
version: 0.0.1
schema: v1

models:
- name: Routerly (auto-routed)
provider: openai
model: routerly/ada
apiBase: http://localhost:3000/v1
apiKey: sk-rt-YOUR_ROUTER_TOKEN

apiBase includes the /v1 suffix. model: routerly/ada is the auto-routing sentinel: selecting it in Continue lets Routerly pick the actual upstream model per request. Replace http://localhost:3000/v1 with your Routerly instance's URL and sk-rt-YOUR_ROUTER_TOKEN with a router token (create one on the Routers page, or let clients configure mint one for you).

Undo​

Every configure run prints a Backup ID. Restore the file to its exact prior state with:

routerly clients undo <backupId>

See CLI: routerly clients for the full command reference, including inspect (check current status) and doctor (check service reachability).